Attaching Or Removing Battery Pack - Panasonic EY4640 Instructions D'utilisation

Installing or removing disc
Inspection before use
• Has the correct grinding disc
been mounted for the object to be
ground?
• Has the proper diameter of the
grinding disc been mounted for
the tool rating?
• Has the proper grinding disc
compiled to safety standard listed
below been mounted?
Europe – EN, Australia - AS
CAUTION:
• When using, the Grinding disc guard
must be installed on the tool so that
the closed side of the guard always
faces toward the operator.
• Ensure that blotters are used when
they are provided with the bonded ab-
rasive product and when they are re-
quired;
WARNING:
• Always use supplied guard when us-
ing tool. Grinding disc can shatter
during use and Grinding disc guard
helps to reduce chances of personal
injury.
1. Install the Grinding disc guard, and
then securely tighten the screw.
Make sure
the side.
2. Install the disc flange and the disc
to the spindle in order as shown in
the figure.
3. Tighten the clamp nut onto the
spindle so that hollow side faces
opposite direction to the disc.
4. Push the Spindle lock button to
1
1. Grinding disc
guard
2. Spindle
3
3. Grinding disc
2
guard fixing
5. To remove the grinding disc, follow
screw
Attaching or Removing Battery
Pack
1. To connect the battery pack:
2. To remove the battery pack:
1. Clamp nut
1
2. Grinding disc
3. Disc flange
2
3
- 14 -
secure the spindle in place, and
then use the clamp nut wrench to
tighten the clamp nut securely.
1
the installation procedure in re-
verse.
Line up the alignment marks and at-
tach the battery pack.
• Slide the battery pack until it locks
into position.
Alignment marks
Pull the button from the front to re-
lease the battery pack.
Button
1. Spindle lock
button