Getting Started - Newell Rubbermaid DYMO RhinoPRO 3000 Guide D'utilisation

About Your New Printer
With your new DYMO RhinoPRO
printer, you can create a wide variety of high-
quality, self-adhesive labels. You can choose to
print your labels in many different sizes and styles.
The printer uses DYMO RhinoPRO Industrial label
cassettes in widths of 1/4" (6 mm), 3/8" (9 mm), or 1/2"
(12 mm). RhinoPRO label cassettes are available in
a wide range of materials.
Visit www.dymo.com for information on obtaining
tapes and accessories for your printer.
Warranty Registration
Please complete the warranty registration card and
return it to the appropriate customer service address,
or you can register online at www.dymo.com.

Getting Started

Follow the instructions in this section to print your
first label.
Power Supply
The printer can operate on AC or battery power. To
save power, the printer will automatically turn off
after five minutes of inactivity.
Inserting the Batteries
The printer uses six 1.5 volt AA alkaline batteries.
To insert the batteries
1. Press the thumb latch on the bottom of the
printer to open the battery compartment door.
See Figure 2.
™
3000 label
Press thumb
latch
Figure 2
2. Insert the batteries following the polarity
markings (+ and –).
3. Close the battery compartment door.
Remove the batteries if the printer will not be
used for a long period of time.
Connecting the AC Adapter
You can also use an optional AC power adapter to
power the printer. Connecting the AC adapter
disconnects the batteries as a power source.
To connect the AC adapter
1. Plug the power adapter into the power connector
on the top of the printer.
Figure 3
2. Plug the other end of the power adapter into a
power outlet.
3