Speci¿ Cations - Panasonic TY-PG70LF50 Instructions D'installation

Fitting procedure (Continued)
5. Setting the Protective Glass on top of the display
5-1. Remove the protective film from the back side of the Protective
Glass, and set the Protective Glass on the rubbers that you
have placed on the display.
• 4 or more people should carry the product.
• Be careful not to hit the Protective Glass on the display panel.
• Ensure the Protective Glass is clean and free of dust, dirt or stains.
• Be careful to prevent dust or dirt from entering into the space
between the Protective Glass and the display panel.
• The side with the label is the back of the Protective Glass. Fit
the Protective Glass on the display in such a manner that the
label will be located at the lower left side.
Back side
Label (back side)
Lower side
Align the outline of the
Protective Glass with
that of the display panel.
Protective Glass
Display panel
5-2. Remove the protective film from the front side of the Protective
Glass.
Speci¿ cations
Dimensions
Weight
Transmittance
20
Protective Glass
Front side
Remove the protective ¿ lm
Upper side
Protective
Glass
Rubber
Remove the protective film
TY-PG70LF50
1564 mm (61.6") (Width) × 900 mm (35.5") (Height)
× 1.3 mm (0.06") (Thickness)
Approx. 5 kg (Approx.11.0 lbs)
6. Reinstalling the cabinet
6-1. Reinstall the cabinet in the order shown in the ¿ gure
below, and secure it with the screws (20) that you have
unscrewed in step 1-1.
(Tightening torque: 0.9 to 1.1 N • m)
④
Cabinet positioning
①
Lower side
Be careful not to trap the wire(s) of the PC
board between the cabinet and the display.
※
※
Tighten those screws in the positions marked with ※ ¿ rst
1819 mm (71.6") (Width) × 1044 mm (41.1") (Height)
× 1.3 mm (0.06") (Thickness)
Approx. 6.5 kg (Approx.14.3 lbs)
Approx. 93 %
Upper side
②
③
※
TY-PG80LF50
※