Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
- GB -
- GB -
Translation of the original Operating Instructions
Information about these operating instructions
Welcome to OASE Living Water. You made a good choice with the purchase of this product Underwater Switch
24V/DMX/02.
Prior to commissioning the unit, please read the instructions of use carefully and fully familiarise yourself with the unit.
Ensure that all work on and with this unit is only carried out in accordance with these instructions.
Adhere to the safety information for the correct and safe use of the unit.
Keep these instructions in a safe place! Please also hand over the instructions when passing the unit on to a new
owner.
Symbols used in these instructions
The symbols used in this operating manual have the following meanings:
Risk of injury to persons due to dangerous electrical voltage
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate meas-
ures are not taken.
Risk of personal injury caused by a general source of danger
This symbol indicates an imminent danger, which can lead to death or severe injuries if the appropriate meas-
ures are not taken.
Important information for trouble-free operation.
A
Reference to one or more figures. In this example: Reference to Fig. A.
Product Description
A, B
Underwater Switch 24V/DMX/02 - hereafter called "unit" - is intended for controlling up to four products with 24 V DC.
The unit is connected to the DMX/RDM bus. The four outputs can be accessed via the bus. A RDM-compatible control-
ler, e.g. WECS from OASE, is required. The connected products can be turned on and off individually underwater.
The unit includes a PowerBox 24V DC for connection to a controlled switching power pack (Underwater Power Supply
250 24V/01) and a DMX box for connection to the DMX controller (WECS).
The unit is designed and constructed for operating underwater. However, it can also be installed in dry locations, but
when doing so, avoid direct sunlight.
The switching power pack, DMX controller (WECS) and final consumer are not part of the scope of delivery.
Intended use
In addition to all the safety information, it is also highly important to adhere to the following specifications:
• The unit is exclusively intended for controlling OASE-produced 24 V DC units, e.g. Air Nozzle 24 DC, single-colour
LEDs 24 V DC.
The following restrictions apply to the unit:
− Only use in conjunction with units intended by OASE for this purpose.
• Operation under observance of the technical data.
Scope of delivery
The scope of delivery includes the Underwater Switch 24V DC/DMX/02.
Operation requires the following units, which are not included in the scope of delivery:
• One electronic 24 V switching power pack with a maximum residual ripple of 5 % and DC decoupling between the
primary and the secondary side.
• A DMX-compatible controller (WECS from OASE).
12
30539-10-13_GA_Underwater Switch12 12
29.10.2013 10:16:30
Publicité
Table des Matières
