Dema MixRite 568 AG Manuel Utilisateur page 7

In models 574(CL/CW), 575(CL/CW) there
is noU-latch and the adjustment is done
by turning the adjustment sleeve to the
desired %.
In models 568 AG and 571 Green there is
no possibility to adjust the dosing percentage
it is predeterment by the injector model
(see page 3)
Rinsing and Cleaning the unit
After pumping
• Rinse the unit by pumping clean water from the additives
• Wash the external surface of the unit with clean water.
Air-release Valve
In models: 568 AG, 571 Green, 570(CW/CL/PVDF),
572(CW/CL/PVDF), 574(CL/CW), 576IN, 578IN.
After initial operation of the MixRite, apply pressure to the cap (the
air release valve) for several seconds to open valve that allows
trapped air to escape. This air release is accompanied by a slight
loss of water. Release the pressure on the cap to close the valve.
I-870
Rev G - 37915
DO NOT REMOVE THE LOWER U-LATCH !!!
(For maintenance purpose only)
container.
Warning: During pumping, ensure that the additive
container is not completely empty.
Press to release air
U-latch
To decrease To increase
Air is released with a
small amount of
water
Page 7 of 36