Troubleshooting; Accessories; Limited Warranty - Schumacher Electric INSTANT POWER IP-55 Guide D'utilisation

Aide de démarrage et source d'énergie cc
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

6.

TROUBLESHOOTING

PROBLEM
The Instant Power™ won't
jump start my car.
The Instant Power™ won't
power my 12V device.
The battery in the Instant
Power™ won't hold a
charge.
7.

ACCESSORIES

Male-To-Male Accessory Cable-------------------------------------38-99-001564
8.

LIMITED WARRANTY

SCHUMACHER ELECTRIC CORPORATION, 801 BUSINESS CENTER
DRIVE, MOUNT PROSPECT, IL 60056-2179, MAKES THIS LIMITED
WARRANTY TO THE ORIGINAL RETAIL PURCHASER OF THIS PRODUCT.
THIS LIMITED WARRANTY IS NOT TRANSFERABLE OR ASSIGNABLE.
Schumacher Electric Corporation (the "Manufacturer") warrants this Instant
Power™ for one year and the internal battery for ninety days from the date of
purchase at retail against defective material or workmanship that may occur
under normal use and care. If your unit is not free from defective material
or workmanship, Manufacturers obligation under this warranty is solely to
repair or replace your product, with a new or reconditioned unit, at the option
of the Manufacturer. It is the obligation of the purchaser to forward the unit,
along with mailing charges prepaid to the Manufacturer or its authorized
representatives in order for repair or replacement to occur.
POSSIBLE CAUSE
Clips are not making a
good connection to the
battery.
The Instant Power™
battery is not charged.
The vehicle's battery is
defective.
The 12V device is not
turned on.
The Instant Power™
battery is not charged.
The 12V device draws
more than 15A or has a
short circuit
The battery is bad (will not
accept a charge).
6
REASON/SOLUTION
Check for poor connection
to battery and frame. Make
sure connection points are
clean. Rock clips back and
forth for a better connection.
Check the battery charge
status by pressing the
button on the front of the
Instant Power™. See LED
Indicators section of this
manual.
have the battery checked.
Turn on the 12V device.
Check the battery charge
status by pressing the
button on the front of the
Instant Power™. See LED
Indicators section of this
manual.
Disconnect the 12V device.
The internal breaker will
automatically reset after a
minute or two. Try the 12V
device again. If it happens
again, replace the 12V
device.
have the battery checked.

Publicité

Table des Matières
loading

Table des Matières