Symbols - Triton T12 DD Instructions D'utilisation Et Consignes De Sécurité

power tool or these instructions to operate the
power tool. Power tools are dangerous in the hands of
untrained users.
e) Maintain power tools. Check for misalignment or
binding of moving parts, breakage of parts and
any other condition that may affect the power
tool's operation. If damaged, have the power tool
repaired before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges are
less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits etc.
in accordance with these instructions, taking into
account the working conditions and the work to
be performed. Use of the power tool for operations
different from those intended could result in a
hazardous situation.
5) Service
a) Have your power tool serviced by a qualified repair
person using only identical replacement parts.
This will ensure that the safety of the power tool is
maintained.
Battery Charger Safety
Use the battery charger correctly
• Refer to the section of this manual relating to use of the
battery charger before attempting to charge the battery.
• Do not attempt to use the charger with any batteries
other than those supplied. Keep your battery charger
clean; foreign objects or dirt may cause a short or block
air vents. Failure to follow these instructions may cause
overheating or fire
• If the supply cord is damaged, it must be replaced by
the manufacturer, its service agent or similarly qualified
persons in order to avoid a hazard

SYMBOLS

ENVIRONMENTAL PROTECTION
Waste electrical products should not be
disposed of with household waste. Please
recycle where facilities exist. Check with your
local authority or retailer for recycling advice
Always wear ear, eye and respiratory
protection
Conforms to relevant legislation
and safety standards
Instruction warning
T3.15A Internal fuse is time lag and maximum
current is 3.15A
Warning: Do not recharge non-rechargeable batteries
Use batteries correctly
• Only charge batteries using the charger provided. Only
use batteries provided with this power tool, or others
recommended by the supplier. Keep batteries clean;
foreign objects or dirt may cause a short. Allow batter-
ies to cool for 15 minutes after charging or heavy use.
Failure to follow these instructions may cause overheat-
ing or fire.
• When not in use batteries should be stored at room
temperature (approx 20˚C). Ensure that batteries cannot
accidentally short in storage.
Battery and charger safety features
The battery and charger are fitted with a number of safety
features which may be triggered during charging or
operation:
• Over-charge protection: Charger automatically switches
off when the battery has reached full charge capacity,
protecting the internal components of the battery
• Over-discharge protection: Prevents the battery from
discharging beyond the recommended lowest safety
voltage
• Over-heat protection: Sensor switches off the tool if
the battery becomes too hot during operation. This can
happen if the tool is overloaded or being used for ex-
tended periods of time. Up to 30 minutes' cooling time
may be required, depending on the ambient tempera-
ture
• Overload protection: Battery temporarily stops if it is
overloaded or the maximum current draw is exceeded,
protecting the internal components. The battery will re-
sume normal operation when the current draw returns
to a normal safe level. This may take a few seconds
• Short circuit protection: The battery will stop working
immediately if a short circuit occurs, this prevents dam-
age to the battery or tool
Double insulated for additional
protection
Li-ion battery cells are recyclable and
should not be disposed of with household
waste. Please recycle where facilities exist.
Check with your local authority or retailer
for recycling advice
Li-ion
Do not incinerate battery packs
Do not use before viewing and
understanding the full operating
instructions
Safety Instructions / Symbols
GB
5