Business Source 20892 Guide D'utilisation page 3

ENGLISH
cONTROLS
Important: sealed laminate
end must go in first
Feed out
Feed in
OPERATION
Hot Lamination
1. Place the machine on a flat, sturdy surface and Set the Laminator to 'Hot'. Press
the power button 'ON'.
2. The machine will take approximately 3-5 minutes to warm up. Laminating can
begin when the green "Ready" light turns on.
3. Place the item to be laminated into the laminating pouch.
4. Insert the pouch film into the front opening of the laminator. Make sure to place
the sealed end of the pouch film in first.
5. The document or photo will then automatically feed out the through the back of
the machine.
NOTE: Laminated items exiting the machine may be too hot to touch.
6. If the item is not completely laminated, repeat steps 4-5.
NOTE: Laminated items will be hot and will easily bend. To keep the item flat, place
on a flat surface and allow it to cool.
Before laminating important or unique documents, always test a pouch
Cold Lamination
1. Place the machine on a flat, sturdy surface Set the Laminator to 'Cold'. Press the
power button 'ON'.
2. The green ready light will turn on. You can begin to laminate the item. (Please note:
You will need to use self-adhesive cold laminating puch film). If the machine was
previously used in hot setting, allow approximately 25 minutes for the machine to
cool down.
3. Place the document to be laminated on the adhesive side of the cold film with the
document face down, sealed end first.
4. Insert the document to be laminated into the front opening of the machine.
5. Remove paper liner from the cold film slowly while the document is being
inserted into the machine.
Important Note: Ensure the laminator is turned OFF after use and disconnected
from the electrical outlet
Ready indicator (Green)
through the laminator using a similar document.
Power Light (Red)
Hot/Cold
Setting
3
Model • 20892/20893
Anti Blockage
System button
ON / OFF Switch