KONIG ONSTAGE OSP-SX110ta Mode D'emploi page 2

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 10
Active Speaker System 15" + 12"
Rear Panel Description – Top Speaker
01. Mic/line input
02. Mic gain
03. EQ control high
04. Peak indicator
05.Master volume
06. EQ low control
07. Low cut/full range
switch
08. Through
(full range output)
09. Main input
10. Power switch
11. Power in
12. Fuse holder
13. Power out
ENGLISH
XLR/1/4 TRS (tip-ring sleeve) input jack
Adjust microphone level
EQ setting for high frequencies
The peak indicator prevents the amplifier outputs from overdriving the
transducers. It lights up when the limiter is activated. It is okay for the peak
indicator to blink occasionally, but if it blinks frequently or lights up continuously,
turn down the level control.
This knob adjusts all signal input or mic level.
EQ setting for low frequencies
When the switch is turned off, the top speaker can be used as a full range
speaker.
Male XLR-type connector that produces exactly the same signal that is connected
to the main input jack. Use it to daisy-chain several active systems of the same
signal source together.
Female XLR-type connector that accepts a balanced line-level signal from a
mixing console or other signal source.
Use this switch to turn the system on and off. Make sure the signal source level
control is turned down before you turn it on.
This is where you connect the AC line cord to provide AC power. Plug the line cord
into an AC socket properly configured for your particular model.
When a problem occurs in this system, the fuse will cut off the power. To replace,
use a standard fuse as specified.
AC power out to top system or another active system which is equipped with
powercon-3.
2

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Osp-sx112taOsp-sx115saOsp-sx118sa

Table des Matières