mebby NO TOUCH Mode D'emploi page 133

Table 4
For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING
Recommended separation distances between portable and mobile RF communications equipment and the No Touch
The No Touch is intended for use in an electromagnetic environment in which radiated RF disturban-
ces are controlled. The customer or the user of the No Touch can help prevent electromagnetic interfe-
rence by maintaining a minimum distance between portable and mobile RF communications equipment
(transmitters) and the No Touch as recommended below, according to the maximum output power of
the communications equipment.
Rated maximum output
power of transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation
distance d in meters (m) can be estimated using the equation applicable to the frequency of the trans-
mitter, where P is the maximum output power rating of the transmitter in watts (W) according to the
transmitter manufacturer.
NOTE 1 At 80 MHz and 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2 These guidelines may not apply in all situations. Electromagnetic propagation is affected by
absorption and reflection from structures, objects and people.
100022_MEBBY NO TOUCH USER MANUAL_REV.00_21.04.2016.indd 133
Separation distance according to frequency of transmitter
150 kHz to 80 MHz 80 MHz to 800 MHz
d = 1.2
0.12
0.38
1.2
3.8
12
m
800 MHz to 2.5 GHz
d = 1.2
0.12
0.38
1.2
3.8
12
d = 2.3
0.23
0.73
2.3
7.3
23
133
14/06/2016 11:33:07