mebby NO TOUCH Mode D'emploi page 132

Table 3
For ME EQUIPMENT and ME SYSTEMS that are not LIFE-SUPPORTING
Guidance and manufacturer's declaration – electromagnetic immunity
The No Touch is intended for use in the electromagnetic environment specified below.
The customer or the user of the No Touch should assure that it is used in such an environment.
Immunity test
Electrostatic discharge
(ESD)
IEC 61000-4-2
Electrical fast transient/
burst
IEC 61000-4-4
Surge
IEC 61000-4-5
interruptions and voltage
variations on power sup-
ply input lines
IEC 61000-4-11
Power frequency
(50/60 Hz) magnetic field
IEC 61000-4-8
NOTE UT is the a.c. mains voltage prior to application of the test level.
132
100022_MEBBY NO TOUCH USER MANUAL_REV.00_21.04.2016.indd 132
IEC 60601 test level Compliance level
6 kV contact 6 kV contact
8 kV air 8 kV air
2 kV for power supply lines Not applicable
1 kV for input/output lines
1 kV line(s) to line(s) Not applicable
2 kV line(s) to earth
< 5 % UT (> 95 % dip in UT) Not applicable
for 0.5 cycle
40 % UT (60 % dip in UT)
for 5 cycles
70 % UT (30 % dip in UT)
for 25 cycles
< 5 % UT (> 95 % dip in UT)
for 5 sec
3 A/m 3 A/m
Electromagnetic environment –
guidance
Floors should be wood, concrete or
ceramic tile. If floors are covered with
synthetic material, the relative humi-
dity should be at least 30 %.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
environment.
Mains power quality should be that
of a typical commercial or hospital
environment. If the user of the No
Touch requires continued operation
during power mains interruptions, it
is recommended that the No Touch
be powered from an uninterruptible
power supply or a battery.
Power frequency magnetic fields
should be at levels characteristic of a
typical location in a typical commer-
cial or hospital environment.
14/06/2016 11:33:06