Step-By-Step Installation Instructions; Install The Low Profile Bracket For Rear Or Bottom Entry Wiring - Tesla J1772 Manuel D'installation

Install the Low Profile Bracket for
Rear or Bottom Entry Wiring
Use the low profile bracket, shown below, to
wire the Wall Connector from the rear or
bottom.
1. Use the low profile bracket as a guide to
mark the location on the wall for the
mounting screws.
• Use a level to ensure that the marks
are perfectly vertical.
• Space the holes 4.5" (114 mm) apart.
• For U.S.A. installations, position the
bracket so that the Wall Connector is
located at a maximum of 60" (150 cm)
from floor level. The minimum height
is 18" (45 cm) if mounting indoors,

Step-by-Step Installation Instructions

Step-by-Step Installation Instructions
2.
and 48" (122 cm) if mounting
outdoors.
• If using the rear entry conduit, use at
least one set of the edge mounting
holes so that the conduit does not
interfere with the wall stud.
• If using the bottom entry conduit, use
the two center mounting holes.
Note: Ensure that the minimum and
maximum height of the bracket is carefully
selected. It should be installed out of the
way of any reasonably foreseeable
impacts.
Attach the bracket using fasteners that
are appropriate for the type of wall
material, drilling pilot holes if necessary.
Use the supplied screws only if mounting
the bracket directly to a wooden stud. If
mounting to another type of wall (hollow,
masonry, etc.), use fasteners that are long
enough to securely anchor the Wall
Connector and can hold at least 80 lb (36
kg).
13