Tools And Materials Required - Tesla J1772 Manuel D'installation

Step-by-Step Installation Instructions

Tools and Materials Required

Before installing the Wall Connector, gather
the following tools and materials:
• Pencil or marker
• Hole punch (optional, to push through
cardboard template)
• Wire stripper
• Voltmeter or digital multimeter (to
measure AC voltage at the installation
site)
• Phillips screwdriver
• Small flathead screwdriver
• Large flathead screwdriver (optional, to
remove plastic knock-outs)
• T20 security pin Torx driver (included)
• T10 Torx driver (included)
• M20 and M32 cable glands (also known as
sealing hubs)
• Wiring (use 18 AWG twisted pair
communication cable at a maximum of 49
ft (15 m) between Wall Connectors)
• Level
• Machine drill
• Torque driver (for terminal block
connections)
Overview of Installation Steps
Warning: After you run service wiring to
the installation site, install the appropriate
upstream circuit breaker, TURN OFF AND
VERIFY POWER IS OFF BEFORE
CONTINUING.
12
Then follow these steps to install the Wall
Connector:
• Install the Low Profile Bracket for Rear or
Bottom Entry Wiring on page 13
• Install the Top Entry Bracket for Rear or
Top Entry Wiring on page 14
• Prepare for Installation on page 15
• Connect the Wiring on page 16
• Set the Operating Current on page 18
• Secure the Cover and Power Up on page
19