Heating Mode - Racer INVERTER 7 Notice D'installation Et D'utilisation

Operation logic of Auto Mode:
Set water temperature
(Tset)
Tset (eg: 28℃)
Tset (eg: 28℃)
7.4.3 and
Clock/unclock the display:
Hold and
Water temperature setting:
Press or
Parameter checking:
Press first, then press
Code
d0
d1
d2
d3
d4
d5
Current water in
temperature (Tset +2℃)
Tset +2℃ (eg:30℃)
Tset-2℃(eg: 26℃)
button
for 5 seconds to lock/unlock the display.
to set the water temperature directly.
to check the " User parameter from d0 to d11
Condition
IPM mould temperature
Inlet water temp.
Outlet water temp.
Ambient temp.
Frequency limitation code
Piping temp.
Auto Mode
LED ON

Heating mode

LED ON
Current working
mode
Heating mode
Cooling mode
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
0,1,2,4,8,16
-30℃～70℃
- 69 -
After 3 minutes or above,
it will switch to
Cooling mode
Heating mode
Remark
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value