Connect To Power Supply; Reset Device - BASETech 1837836 Mode D'emploi

d) Connect to Power Supply
The blue LED indicates that the device is receiving
power.
• Connect the power adapter to an electrical outlet and insert
the supplied USB cable.
• Insert the other end of the cable into the micro USB socket on
the back of the device.
• Wait until you hear a voice prompt indicating that the system
is starting up (approx 30 seconds).
• A second voice prompt will indicate when start up is complete.
The LED will blink rapidly.
If this does not happen, see section f) "Reset Device".
• You can now connect to and configure the camera using the
"V12" application software.
e) Reset Device
Resetting the device restores all settings including
device passwords to factory defaults.
The default password for your device is 123456.
If you do not hear any voice prompts and the LED indicator
flashes slowly, press and hold RESET button for approximately
5 seconds.
35