Closing The Door; Installation; Electrical Connection; Door Reversibility - AEG SCS51800S1 Notice D'utilisation

12 www.aeg.com
2

6.2 Closing the door

1. Clean the door gaskets.
2. If necessary, adjust the door. Refer
to "Installation".

7. INSTALLATION

WARNING!
Read the "Safety Information"
carefully for your safety and cor-
rect operation of the appliance
before installing the appliance.
7.1 Positioning
Install this appliance at a location where
the ambient temperature corresponds to
the climate class indicated on the rating
plate of the appliance:
Cli-
mate
class
SN
N
ST
T
1
1
Ambient temperature
+10°C to + 32°C
+16°C to + 32°C
+16°C to + 38°C
+16°C to + 43°C
1. At the same time, with the fingers ex-
pand up and down the transparent
cover and unhook it in the direction of
the arrows.
2. Replace the lamp with one of the same
power and shape, specifically designed
for household appliances. (the maxi-
mum power is shown on the light bulb
cover).
3. Reassemble the lamp cover.
4. Connect the plug to the mains socket.
5. Open the door. Make sure that the
light comes on.
3. If necessary, replace the defective
door gaskets. Contact the Service
Center.

7.2 Electrical connection

Before plugging in, ensure that the volt-
age and frequency shown on the rating
plate correspond to your domestic pow-
er supply.
The appliance must be earthed. The
power supply cable plug is provided
with a contact for this purpose. If the do-
mestic power supply socket is not earth-
ed, connect the appliance to a separate
earth in compliance with current regula-
tions, consulting a qualified electrician.
The manufacturer declines all responsi-
bility if the above safety precautions are
not observed.
This appliance complies with the E.E.C.
Directives.

7.3 Door reversibility