Unit Diagram - Marshall Amplification Eden Astroflange Manuel D'utilisation

1. Output; Connect to your amplifier or other outboard equipment
here using a 1/4" jack cable.
2. Velocity; Adjust the speed of the Flanger effect using this control.
3. LED indicator; When illuminated the unit is receiving power from
the included 15V Eden power supply.
4. Altitude; Control the height of the Flanger effect using this
control.
5. Low Cut; Decide how much or how little low end bass is affected
by the pedal here.
6. Effect level; Adjust the effect level here, use this to balance your
sound against the pedals off mode.
7. Power in; Insert your included Eden 15V power supply here to
power the pedal.
8. Input; Connect your instrument here using ¼" input socket.
9. OFF / ON switch; Turn the effect off or one using this switch,
LED indicator will illuminate when the effect is on.
3
2 4
1

unit diagram

7
5 6
8
9
Quick Start Guide | Astroflange
7