Solar Freeloader Pico PC1005 Mode D'emploi page 6

3. Checking how much power is in
Freeloader Pico's internal battery
To determine how much power is available
in Freeloader Pico simply connect a device
to Pico (using the Master Cable and tip or a
device's sync cable). Upon connection, LED's
E, F , G and H will illuminate (fig 2)
LED Illuminated
No LED's
LED E
LED E and F
LED E, F and G
LED E, F , G and H
4. To charge a device from
Freeloader Pico
Insert the USB end of the Master Cable into
the Power Out socket (B, fig 1). Select the
correct adaptor tip and insert into it
the other end of the Master Cable.
Note – if your device is not supported by
one of the adaptor tip's in this pack you can
connect the USB sync/charge cable that
was originally supplied with your device into
Freeloader Pico's Power Out socket (B, fig 1).
Finally insert the tip (from the Master Cable or
a sync cable) into the device to be charged.
5. Solar Reset Button
If Freeloader Pico's battery has been fully
drained, you can speed up the charging
process (if charging by solar) by pressing the
Solar Reset Button (D, fig 1) for 3 seconds.
Note - this Button only works if the solar panel
is facing daylight when button is pressed.
Power Available
0% to < 35%
35% to < 60%
60% to < 85%
85% to < 100%
100%
4