Hendi 281246 Mode D'emploi page 5

Grounding installation
This appliance is classified as class I protection
appliance and must be connected to a protective
ground. Grounding reduces the risk of electric
shock by providing an escape wire for the electric
Preparations before using for the first time
• Check to make sure the appliance is undamaged.
In case of any damage, contact your supplier im-
mediately and do NOT use the appliance.
• Remove all the packing material.
Preparations before wall mounting
Before installation: check the UV sterilizer and it's
screw holes at the back for any damage.
Note: Mounting screws, studs and tools are not in-
cluded and consult a qualified contractor or install-
er for assistance if you are not certain about the
structure of the wall and ensure that the procedure
is carried out properly and safely.
• Important: make sure the appliance is mounted
within the reach of the electrical outlet.
• Important: do not mount the UV sterilizer on dry-
wall or paneling without first anchoring to a wall
stud!
• Important: Before starting mounting, make sure
you have all the tools, such as screw driver, elec-
tric drills, measuring tape, marking pencil (All
are not included).
• The hinged distance is about 360 mm between
the screw holes.
Operation
• Open the door and place the knives after their
cleaning and drying.
• Then, plug into a suitable electrical outlet.
• Switch on the appliance by pressing the main
switch to the "I" position. Green indicator on the
main switch light up and rotate the timer to the
desired time to activate sterilization process.
• UV lamps will start illuminating inside. Knives
will be started for sterilization inside.
current. This appliance is equipped with a cord
having a grounding wire with a grounding plug. The
plug must be plugged into an outlet that is properly
installed and grounded.
• Clean the appliance with luke-warm water and
a soft cloth.
• Level the appliance.
• Position the appliance in such a way that the plug
is accessible at all times.
• The sterilizer must be securely anchored on a
wall by attaching two of the brackets with 1/4"
bolts to the centre of an interior vertical wall stud
and the other two brackets to the wall using 1/4"
expanding toggle bolts. (not included)
• Locating wall studs: anchoring wall stud assures
that your UV sterilizer will not loose during oper-
ation. Note: be aware that items such as ducts,
electrical wires and water pipes may be behind
the walls in your work area. Special care when
installing fasteners.
• For attaching the UV sterilizer securely to other
wall surfaces such as concrete or brick, see your
local hardware store for recommendations on
using the appropriate concrete and masonry fas-
teners and anchors for your particular structure.
• After you have mounted the bolts, simply slide in
the UV sterilizer from the top onto the bolts.
• UV lamps will go off when the set time is reached
and a "Ding" sound will be heard. Then, switch off
the appliance by pressing the main switch to the
"0" position. The green indicator will then go off.
• If you do not use the appliance for an extended
period, remove the plug from the main socket
and remove all knives.
Note: The UV light will go off once the door is
opened.
EN
5