Important; Warning; List Of Supplied Components - Unico Digitemp Manuel D'installation, Emploi Et Entretien

THE MANUFACTURER IS NOT RESPONSIBLE FOR DAMAGES TO PERSONS OR PROPERTY CAUSED BY FAILURE TO
FOLLOW THE INSTRUCTIONS IN THIS MANUAL.
The manufacturer reserves the right to modify at any time its models without changing the fundamental characteristics described
in this manual.
The installation and maintenance of air-conditioners like this one may be hazardous as they contain a cooling gas under pressure
as well as powered parts.
Therefore, the installation, first startup and subsequent maintenance should be carried out exclusively by authorized,
qualified personnel.
This unit complies with European Directives 2006/95/EC, 2004/108/EC, 2002/95/EC and 2002/96/EC.
Failing to comply with the instructions contained in this manual, and using the unit with temperatures exceeding the permissible
temperature range will invalidate the warranty.
Routine maintenance of the filters and general external cleaning can be done by the user as these operations are not difficult or
dangerous.
During the assembly and each maintenance operation, always pay attention to the warnings described in this manual and on the
labels affixed inside the appliances, and respect anything suggested by common sense and those of the Safety Norms in force
in the place of installation.
Always wear gloves and protective goggles when carrying out interventions on the cooling part of the appliance.
Conditioners MUST NEVER be installed in rooms where there is inflammable gas, explosive gas, a high level of humidity (laundry
rooms, greenhouses etc), or in rooms where there are other machines that generate a lot of heat.
Should components need replacing, always use XPELAIR original spare parts.

IMPORTANT!

To avoid any risk of electric shock always remove the master plug from the mains before making any electrical connections
or any other maintenance intervention on the appliances.
Make sure that all personnel responsible for transport and installation of the appliance are aware of these instructions.
IMPORTANT!
Do not allow R-410A to escape into the atmosphere: R-410A is a fluorinated greenhouse gas, as cited in the Kyoto Protocol, with
a Potential Global Warming effect (GWP) = 1975.
DISPOSAL
The symbol on the product or on the packaging indicates that the product must not be considered as normal domestic refuse but
it must be taken to an appropriate disposal point for recycling electrical and electronic appliances.
Disposing of this product in the appropriate way avoids causing potentially negative consequences both for the environment and
for the health that could occur if the product is not disposed of correctly.
Further information about the recycling of this product can be obtained from your local town hall, your refuse collection service, or
in the store at which you bought the product.
This regulation is valid only in EU member states.
1.3

WARNING

The air-conditioner should be used for the exclusive purpose of producing hot or cool air (on demand) for the sole purpose of
obtaining a comfortable temperature in the room.
Improper use of the equipment, which may cause injury/damage to persons, property or animals, relieves XPELAIR of any liability.
1.4

LIST OF SUPPLIED COMPONENTS

The supply includes the parts listed in the table below (fig. 1). Before beginning to assemble the unit, make sure all the
parts are within easy reach.
A - Strip of adhesive isolating tape
B - Air inlet and outlet external grids including chains and kit for installing the grids (n.2)
C - Internal flanges (2)
D - Sheet for wall pipes
E - Kit of screws and anchor bolts
F - Wall anchoring bracket
G - Use and maintenance booklets + warranty
H - Remote control
I - Paper template to make holes
1
11