STERWINS 8VGS2-3IN1.11 Notice De Montage, Utilisation Et Entretien page 253

Clean and lubricate the blades
To ensure many years of efficient and trouble-free operation, blade cleaning should be performed if
sap and debris have built-up, or if you live in an area where the soil is sandy. Cleaning unusually heavy
deposits may require removal of the blades. For easier operation and longer blade life, lubricate the
hedge trimmer blade before and after each use. Stop the product. Lay the battery grass shear on a flat
surface. Apply lightweight product oil along the edge of the top blade. If you will be using the battery
grass shear for an extended period, it is advisable to stop work intermittently in order to re-oil the blade.
NOTE: Do not oil while the battery grass shear is running.
8.2 REPLACEMENT
Fitting and changing the blades 2.1 to 2.9
The battery grass shear is equipped with two interchangeable blades. The hedge trimmer blade is used
to cut hedges and shrubs while the grass shear blade is used to cut grass and hedges where finer detail
is required.
1.Turn the battery grass shear upside down holding in one hand on a hard surface.
Gently lift the tab of the blade cover and slide back until the cover can be removed.
2.Gently remove the blade by lifting the end tip of the blade off of the battery grass shear unit.
3.Insert the desired blade into the base of the motor housing.
4.Align the 4 lugs for a secure fitment. The gear shaft in the middle of the blade also has to be aligned.
5.Once the blade is in position, align the blade cover with the slots in the base of the motor housing.
6.Push forward on the blade cover until it slides and clicks into place. The battery grass shear is now ready
for use.
To remove a blade
1.Turn the battery grass shear upside down holding in one hand on a hard surface. Gently lift the tab of
the blade cover and slide back until the blade cover can be removed.
2.Remove the blade gently by lifting the end tip of the blade off the battery grass shear unit.
3.Follow steps 2 - 6 of "Fitting and changing the blades" to secure the blade.
Assemble the steering tube
NOTE: It depends on your working demand whether assembling the steering tube.
1. Install the grass shear into the slot of the steering tube.
2. Connect the steering tube's plug to the socket of the grass shear.
3. To remove, unplug the steering tube's plug and remove the grass shear form the slot.
253
FR
ES
PT
IT
EL
PL
RU
KZ
UA
RO
EN