BEFORE OPERATING, READ AND UNDERSTAND ALL OF THE
INSTRUCTIONS AND SAFETY INFORMATION IN THIS
MANUAL BEFORE OPERATING OR SERVICING THIS TOOL
TABLE OF CONTENTS
Identification............................................................4
Maintenance..................................................................8
Warranty.................................................................9 - 10
SAFETY FIRST
Safety is essential in the use and maintenance of Southwire
Contractor Equipment. This instruction manual and any markings
on the tool provide information for avoiding hazards and unsafe
practices related to the use of this tool. Observe all of the safety
information provided.
SAFETY ALERT SYMBOLS
These symbols are used to call attention to related
hazards or unsafe practices related that could result
in injury or property damage. The three safety words
defined below indicate the severity of the hazard.
The message after the signal word provides
information for preventing or avoiding the hazard.
Immediate hazards which, if not avoided, WILL
result in severe injury or death.
Hazards which, if not avoided, COULD result in
severe injury or death.
Hazards or unsafe practices which, if not avoided,
MAY result in injury or property damage.
FAILURE TO OBSERVE THESE WARNINGS COULD
RESULT IN SEVERE INJURY OR DEATH
SAFETY
ALERT
SYMBOLS
Read and understand all of the
instructions and safety information in
this manual before operating or
servicing this tool.
Failure to observe this warning could
result in severe injury or death.
Personal
safety hazards
• Only qualified persons should use the
MAX PUNCH
®
XD Knock-Out Tool.
• Wear eye protection, gloves and a hard hat when
using this tool.
• Do not use tool while tired or under the influence of
drugs, alcohol, or medication.
• Keep body parts and loose clothing away from
moving parts.
• Always follow safety procedures as shown in
this manual.
1