Troubleshooting; Maintaining And Cleaning The Gas Detector - Dometic MAGICSAFE MSG150 Instructions De Montage Et De Service

MSG150
11

Troubleshooting

If the device is not ready for operation (the green LED does not glow), proceed as follows:
➤ Make sure the power supply is 12 or 24 Vg.
If the voltage is less than this, or the voltage supply has been interrupted, the gas detector
does not function.
➤ Check the fuse in the plug, if the gas detector is connected using a 12 Vg plug.
Checking the fuse in the 12/24 Vg plug
In the tip of the plug, there is a fuse to protect the gas detector.
If the thin metal connection in the middle between the two metal caps is broken, the fuse is
defective and must be replaced. Replacement fuses are available from customer service.
A
NOTICE!
Make sure that you only use the same fuse type (1 A / 250 V) in the plug. Damage to
the device resulting from using inappropriate fuse types is excluded from guarantee
claims under the terms of the warranty.
To replace the fuse, proceed as follows:
➤ Pull the adapter sleeve (fig. 4 4, page 4) off of the plug.
➤ Unscrew the screw (fig. 4 5, page 4) out of the upper half of the housing (fig. 4 1, page 4).
➤ Carefully lift the upper half of the housing off the lower half (fig. 4 6, page 4).
➤ Take out the contact pin (fig. 4 3, page 4).
➤ Replace the defective fuse (fig. 4 2, page 4) with a new fuse that has the same rating.
➤ Re-assemble the plug in the reverse order.
12

Maintaining and cleaning the gas detector

A
NOTICE!
Do not use sharp or hard objects or cleaning agents for cleaning as these may damage
the product.
➤ Occasionally clean the product with a damp cloth.
EN
Troubleshooting
19