Regulatory Notices - DeWalt DCT100 Guide De L'utilisateur

ENGLISH
5. WiFi reception may vary by device. Many laptops, phones, tablets, and
mobile devices have a maximum range of 75–100 ft (22–30 m).
FOR MORE INFORMATION, VISIT WIFI.DEWALT.COM/#/TIPS.

Regulatory Notices

To comply with FCC/IC RF exposure limits for general
population/uncontrolled exposure, the antenna(s)
used for this transmitter must be installed to provide
a separation distance of at least 7.87" (20 cm)
from all persons and must not be co-located or
operated in conjunction with any other antenna
or transmitter.
This device complies with Industry Canada's licence-
exempt RSS and Part 15 of the FCC Rules. Operation
is subject to the following two conditions:
1 . This device may not cause harmful interference,
and
2 . This device must accept any interference
received, including interference that may cause
undesired operation.
NOTE: This equipment has been tested and found
to comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate
radio frequency energy and, if not installed and
used in accordance with the instructions, may cause
harmful interference to radio communications.
However, there is no guarantee that interference
will not occur in a particular installation. If this
4
200' (60 m)
equipment does cause harmful interference to radio
or television reception, which can be determined
by turning the equipment off and on, the user is
encouraged to try to correct the interference by one
or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a
circuit different from that to which the receiver
is connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Conditions or modifications not expressly approved
by the party responsible for compliance could void
the user's authority to operate this equipment.
CAN ICES-3(B)/NMB-3(B)
Under Industry Canada regulations, this radio
transmitter may only operate using an antenna of
a type and maximum (or lesser) gain approved for
the transmitter by Industry Canada. To reduce radio
interference to other users, the antenna type and
its gain should be so chosen that the equivalent
isotropically radiated power (e.i.r.p.) is not more than
that necessary for successful communication.