Fantech GDC124CSS Guide D'utilisation page 4

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

ASSEMBLY
Wheel / Handle Assembly
Wheel / Handle Assembly
1
Position unit on back. Remove 4 shipping
Position unit on back. Remove 4
screws and discard.
shipping screws and discard.
3
Install one short tube on wheel axle.
Install one short tube on wheel axle.
5
Install one short tube. Install one handle
Install one short tube. Install one
screw and tighten.
handle screw and tighten.
7
Install washer and lynch pin to each
Install washer and lynch pin to each
wheel axle end.
wheel axle end.
4
2
Slide wheel axle into wheels brackets.
Slide wheel axle into wheels brackets.
Offset to one side.
Offset to one side.
4
Install bent handle on short tube.
Install bent handle on short tube. Install
one handle screw and tighten.
Install one handle screw and tighten.
6
Install two wheels on wheel axle.
Install two wheels on wheel axle.
WARNING: Personal injury
WARNING:
hazard. Do not place fingers in
Personal injury hazard.
ring area. Ring is spring
Do not place fingers in ring area. Ring
loaded and closes with force.
is spring loaded and closes with force.
Lower Door, Second Handle Assembly
Lower Door, Second Handle Assembly
8
Position unit with air filter up.
Position unit with air filter up.
10
Insert bent tube into long tube. Rotate
Insert bent tube into long tube. Rotate
long tube to align with cabinet hole and
long tube to align with cabinet hole and
insert one handle screw. Do not tighten.
insert one handle screw. Do not tighten.
12
Insert two handle screws. Tighten all han-
Insert two handle screws. Tighten all
dle screws.
handle screws.
4
9
!
Install one long tube, plastic bushing
Install one long tube, plastic bushing
faces inward. Insert one handle screw.
faces inward. Insert one handle screw.
Do not tighten.
Do not tighten.
11
Insert hand axle. Insert second long tube.
Insert hand axle. Insert second long tube.
13
Position unit upright. Wait 30 minutes
Position unit upright.
before starting to allow compressor to
Wait 30 minutes before starting to
drain back.
allow compressor to drain back.

Publicité

Table des Matières
loading

Produits Connexes pour Fantech GDC124CSS

Ce manuel est également adapté pour:

Gdc124csGdc80cs

Table des Matières