Emptying The Drum - Ryobi RMX001 Manuel D'utilisation

 Carefully pour dry and wet mixing material into the drum.
Refer to material manufacturer's instructions for details.
Mixing times may vary.
NOTE: The mixer has a batch capacity of 270 lbs.
(2.5 cu. ft). Do not overload the tool.
 When mixing is complete empty the drum, turn off the
motor, and clean the mixer as described later.

EMPTYING THE DRUM

See Figure 20.
WARNING:
Keep hands away from the drum while it is spinning.
Hands and other body parts can be drawn into the drum
while it is spinning, resulting in serious personal injury.
NOTICE:
Use caution when working with fast hardening material
such as quick set concrete. A few minutes of inactivity
may be sufficient to allow the material to set. Setting times
vary, refer to the material manufacturer's instructions.
NOTICE:
Routinely make a visual inspection of the mixer and the
material being mixed. Do not let materials dry and harden
inside the drum or on any part of the product. Failure to
follow this warning could result in property damage or
malfunction of the product.
 Add and mix materials as described in the previous
section.
 Turn the mixer off.
 Loosen the bolt on the back of the pivot bracket.
 Carefully rotate the drum until it is pointing away from the
frame (front and rear leg) and towards the work area.
 Tighten the bolt at the rear of the pivot bracket to prevent
the drum from rotating.
NOTICE:
Always keep the drum's opening in view when filling or
emptying the concrete mixer. Certain mixing substances
can harden quickly and could cause property damage or
personal injury if spilled.
OPERATION
 Unlock the drum.
 Slowly lift the handles up to lower the drum opening.
 Once the drum is empty or the job is complete, raise the
drum opening and lock the drum in place.
 Clean the mixer as described later.
17 − English
Fig. 19
Fig. 20