Hoover AS70 AS30011 Manuel D'utilisation page 4

GETTING TO KNOW YOUR CLEANER
A. Foldaway Handle
B. Foldaway Handle Release Button
C. Mini Pop-Up Handle
D. On / Off Button or Variable Power Control*
E. Quick Release Cord storage Hook
F. Exhaust Filter
G. Power Cord
H. Integrated Clip
I. Bag Door
J. Bag Check Indicator
K. Carpet and Floor nozzle (GP)**
K1. Carpet nozzle (CA)**
K2. Hard Floor nozzle (HF)**
L. Extension Tube*
M. Furniture nozzle
n. Crevice Tool
O. Accessory Holder
P. Parquet Nozzle
GETTING TO KNOW YOUR CLEANER
Remove all components from the packaging.
• Unclip foldaway handle from base of main body and fold upward into place.
• Open the bag door and check if the dust paper bag is correctly fitted.
• Ensure the pre-motor and exhaust filters are correctly fitted.
• Fit the Carpet and Floor nozzle.
• Fully unwind cord.
• On fixed power version depress button to switch power On/Off. On variable power version
rotate the knob to switch on and control the power.
USING YOUR CLEANER
POWER CORD STORAGE
1. Before use undo integrated clip, turn top hook and release power cord. [Fig. 1]
2. During use as a stick cleaner clip power cord into back of main handle. [Fig. 2]
After use, unclip power cord from handle and wind it around storage hooks before
securing with integrated clip. [Fig. 3]
CONTROLS*
On/Off switch. Push to switch On. Push again to switch Off. [Fig. 4]
1.
2. Variable power control. switch On and set the desired power by rotating the selector.
Rotate back to switch Off. [Fig. 5]
CLEANER MAINTENANCE
BAG & FILTERS
MPORTANT: switch cleaner Off and remove plug from electricity supply before changing
paper bag or removing any filters.
CHANGING THE PAPER BAG
When the bag check indicator shows red, check to see if the bag is full and requires
replacement.
The bag check indicator may show red even if there is a blockage elsewhere in the
product.
For accurate bag check indication, the power control* must be set to maximum.
Replace the paper bag frequently when picking up material such as powder or fine dust
or when cleaning new carpets.
DO NOT overfill the paper bag.
To change the paper bag:
Lay the cleaner on a flat surface, pull back catch and remove bag door. [Fig. 6]
1.
2. Remove bag by pulling bag collar from hose inlet. Remove sticky backing from the
dust flap and fold it over the inlet to avoid dust escaping from the bag. [Fig. 7]
3. Before fitting a new bag, fold the corners of the bag behind the collar. [Fig. 8]
4. slide the collar along the guides and lift over the inlet tube. Collar should 'click' into
place. [Fig. 9]
5. Locate tabs on bag door as shown and close bag door. [Fig. 10]
DO nOT use the vacuum cleaner without a paper bag in place.
IMPORTANT: Hoover recommends that filters are replaced after five full bags have been
used.
REPLACING THE STANDARD PRE-MOTOR FILTER* [Fig. 11]
With paper bag removed lift the pre-motor filter from the bag housing.
Fit the new filter and replace the paper bag.
2
*Certain Models Only
GB
**Nozzle design may vary according to models