Mounting Instructions - D-Link DCS-4703E Guide D'installation

Mounting Instructions

It is highly recommended that you configure and test your camera before
mounting it.
Place the mounting sticker where you want to
position the camera. Make sure the camera base
will be positioned so that the cable channel is on
the bottom.
Use a 6 mm drill bit to make the required holes
approximately 25 mm deep, then insert the wall
anchors into the holes.
If you are running the camera cables through
the wall, drill a hole in the center and pull the
cables through the hole.
Use the screws provided to mount the camera to
the wall.
If you are running the camera cables out the
side of the camera, guide the camera cables
through the cable channel on the base.
Connect the power and Ethernet cables, or just the
Ethernet cable if you are using a PoE connection.
To adjust the camera's angle, turn the adjustment
ring counterclockwise to loosen it, then move the
camera to the desired position and angle. When
you are finished, turn the adjustment ring clockwise
to tighten it.
If you need to waterproof your installation, please continue to the next page.
5
5
D-Link DCS-4703E Quick Installation Guide