Philips SpeedCare GC6600 Série Mode D'emploi page 9

Problem
The appliance
produces a loud
pumping sound.
Water droplets
come out of the
soleplate.
Dirty water and
impurities come
out of the
soleplate.
Water flushes
out of the
soleplate.
The Calc-Clean
process does not
start.
4239_000_9025_3_Booklet Simple_A5_v4.indd 9
Possible cause
The water tank is empty.
After the Calc-Clean process,
remaining water may drip out of
the soleplate.
The Calc-Clean process has not
been completed.
Impurities or chemicals present
in the water have deposited in
the steam vents and/or
soleplate.
You have accidentally started
the Calc-Clean process (see
chapter 'IMPORTANT -
Cleaning and maintenance').
You have not set the
temperature dial to CALC
CLEAN or you have not waited
for the iron to heat up.
You have not pressed the Calc-
Clean button for 2 seconds until
the appliance started beeping.
Solution
Fill the water tank with water and press
the steam trigger until the pumping sound
becomes softer and steam comes out of
the soleplate.
Wipe the soleplate dry with a piece of
cloth. If the Calc-Clean light still flashes and
the appliance still beeps, perform the Calc-
Clean process (see chapter 'IMPORTANT
- Cleaning and maintenance').
You have to perform the Calc-Clean
process again (see chapter 'IMPORTANT -
Cleaning and maintenance').
Perform the Calc-Clean process regularly
(see chapter 'IMPORTANT - Cleaning and
maintenance').
Switch off the appliance. Then switch it
back on again. Turn the temperature dial to
the desired temperature setting instead of
CÁLC CLEAN. Let the iron heat up until
the 'iron ready' light lights up steadily.
See chapter 'IMPORTANT - Cleaning and
maintenance'.
See chapter 'IMPORTANT - Cleaning and
maintenance'.
ENGLISH
9
6/2/15 10:06 AM