Flight Preparation; Package Content - Ugo ZEPHIR 3.0 Guide De Démarrage Rapide

CONTROLLER BATTERY INSTALLATION
1.Loosen the screw and remove the battery cover.
2.Insert 4xAA batteries into the controller according to the indicated polarity.
3.Place the battery cover in place and secure it with the screw.
DRONE BATTERY INSTALLATION AND CHARGING
1.Open the battery cover.
2.Connect the batteries to the charging cable provided. Connect the cable to a USB port (PC/Laptop or network adapter).
3.During charging, the LED glows continuously. After charging, the LED will go out. Estimated charging time is 60 min.
4.Disconnect the battery from the charger by releasing the safety catch (photo 2 from the battery side)
and then re-install the battery in the drone (photo 3).

FLIGHT PREPARATION

1.Press and hold the power button located on the drone for 2 seconds, wait for the fuselage light to ash.
Then place the drone on a level surface.
2.Turn on the controller, move the left stick up and down. The lights on the fuselage will illuminate
and the controller will be successfully connected.
DRONE CONTROL DURING FLIGHT
1.The left controller stick is responsible for the drone's climbing and descent. When you move the stick up,
the drone will begin to climb. When you move it down, the drone will begin to descend.
2.Moving the left control stick to the left will cause the drone to rotate counter-clockwise around its axis.
Moving the left control stick to the right will cause the drone to rotate clockwise around its axis.
3.Moving the right stick to the left will make the drone y to the left.
Moving the right stick to the right will make the drone y to the right.

PACKAGE CONTENT

• Zephir 3.0 drone
• Controller
• USB cable
• Operating instructions
EN
BATTERY
FR DE PL