Table des Matières
Publicité
Annexe B. Menu de configuration
2) Advanced Setup
a) Radio Parameters
b) Interface Parameters (Paramètres de l'interface)
B-2
i) Radio Address Parameters
(1) Net Address (0 – 63)
(2) Radio Address (0 – 1023)
(3) Net Address Mask (0 – 3fh)
(4) Radio Address Mask (0 – 3ffh)
(5) Hop Table (0 – 6)
ii) Radio Standby Modes
(1) Standby Mode
(0 => 24 mA Always ON 3 => 4 mA 1/2 sec Cycle)
(4 => 2 mA 1 sec Cycle 5 => 1 mA 2 sec Cycle)
(6 => .6 mA 4 sec Cycle 7 =>.4 mA 8 sec Cycle)
(1 => Pin Sleep (PakBus Only))
(2) Time of Inactivity to Sleep (1 – 32767) / unités de 100msec.
(3) Time of Inactivity to Long Header (0 – 65535) / unités de 100msec.
Choisir 0 pour avoir les en-têtes longues à chaque fois /
65535 pour ne jamais les utiliser.
(4) Long Header Time (0 – 255) / unités de 100msec.
iii) Radio AT Command Sequence Setup Menu
(1) AT Command Sequence (any ASCII character)
(2) Silence time before Command Sequence (1 – 32767) / unités de 100msec.
(3) Silence time after Command Sequence (1 – 32767) / unités de 100msec.
(4) AT Command Mode Timeout (1 – 32767) / unités de 100msec.
iv) Radio Diagnostics
Number of Retry Failures:
Received Signal Strength:
v) Radio Retry Settings
(1) Number of Retries : (0 – 255)
(2) Number of time slots for random retry (unités de 38 msec; 0 – 255)
(3) Number of bytes transmitted before delay (1 – 65535)
(4) Sync Timer Setting; (unités de 100 msec; 0 – 255)
vi) Configure RF401 for Firmware Download
i) CSDC Address (Not Active): (7 or 8)
ii) RS-232 Auto Power Down Enable
0 => RS-232 always active to power RS-232 devices (Toujours actif pour alimenter les
appareils en RS232)
1 => RS-232 TX automatically powers down when no activity for 30 sec (Automatiquement
l'alimentation se mettra en veille après une inactivité de 30s)
Publicité
Table des Matières
