Switching the mixer on and off
The mixers are equipped with an accelerator
switch. It allows the speed to be gradually
increased up to working speed. Switching on
without locking:
Press and hold down the switch (1.).
To switch off, release the switch (2.).
Switching on with locking:
Press and hold down the switch (1.).
To lock into position, hold down the locking
button (2.) and release the switch.
To switch off, briefly press and then
release the switch (3.).
NOTE!
If the mixer does not turn after switching on:
–
Switch the power tool off (release lock by
pressing switch).
–
Rotate the mixer paddle manually by 45°.
–
Switch the power tool back on again.
Tel. +49 (0)7062 91556 - 0 | Fax +49 (0)7062 91556 - 41 | E-Mail info@wolff-tools.de |
WOLFF | Eine Marke der Uzin Utz AG | 74360 Ilsfeld | Ungerhalde 1
Internet
www.wolff-tools.de
16
Operating instructions
After it has been switched off, the mixer
runs on for a short time.
If the rotating mixer paddle strikes a
surface, it could cause a jolt.
Only switch on the tool after the mixer
paddle has been immersed in the product
to be mixed. When doing this, slowly
press the switch and wait until the tool
has reached maximum speed.
When taking a break from work, place
the tool down on the rests
Overload protection
In the event of a short and extreme overload,
the overload protection device prevents
damage to the motor by switching the tool off
automatically. For further information on the
manufacturer's products go to
www.wolff-tools.com.
Maintenance and care
WARNING!
Before performing any work on the mixer,
pull out the mains plug.
Cleaning
Regularly clean the power tool and
ventilation slots.
Regularly blow out the housing interior
and motor with dry compressed air.
Clean the mixer paddle straight after
use. Do not allow the mixed product to
dry on.