Unitec 10945 Mode D'emploi page 5

• Position the tyre so that the valve is as low as possible.
• Screw the rubber hose connector to the tyre valve. If the tyre is completely empty of air,
the vehicle should be raised a little with a jack so that there is no additional counter-
pressure acting on the empty tyre.
• Put the plug into the cigarette lighter (12 Volt). The compressor is now ready to operate.
• You can set the unit of measurement for pressure with the „SET" button (BAR, PSI, KG/
CM³, KPA)
• Set the desired air pressure with the „+" and „-" buttons and start the compressor with
the „COMPRESSOR ON" button. The device will switch off automatically when the set
pressure is reached. the inflation process may be interrupted by pressing the
„COMPRESSOR OFF" button.
• After use, take the plug back out of the cigarette lighter.
• Select the appropriate adapter and connect the compressor to the item to be inflated.
• Put the plug in the cigarette lighter (12 Volt). The compressor is now ready to operate.
• You can set the unit of measurement for pressure with the „SET" button (BAR, PSI, KG/
CM³, KPA)
• Set the desired air pressure with the „+" and „-" buttons and start the compressor with
the „COMPRESSOR ON" button. The device will switch off automatically when the set
pressure is reached. the inflation process may be interrupted by pressing the
„COMPRESSOR OFF" button. Avoid overinflating the item being inflated as this may
cause it to burst!
• After use, take the plug back out of the cigarette lighter.
• To switch the work light on and off please move the switch to the „LIGHT ON" or
„LIGHT OFF" position.
• Do not look directly into the work light.
• If the housing becomes dirty, wipe it with a damp cloth. Do not immerse the device in
water.
• Operating voltage:
• Maximum pressure:
• Airflow rate:
• Power:
• Rotation speed:
• Noise level (when inflating):
At the end of its working life do not dispose of this product in the domestic refuse
but at the locations set up for the return of used electrical equipment.
DC12V
12 V DC
10 bar
22 litres/min
0.096 – 0.120 kW, 0.214 kg
16,000 rpm
< 85 dB
IC PCB for
pressure
gauge
Hose
Pressure
sensor
K2
PCB
K1
+
M
–
Procedure for
inflating tyres
Procedure for inflating
balls and airbeds
Work light
Cleaning instructions
Technical specifications
Disposal instructions
YC2211B Circuit diagram