The Interior-Cinema set can also be connected to a headphone jack on the TV. A cable adapter is
generally required for this purpose (not included in delivery). The TV's speakers are usually switched off
automatically when using the headphone jack. The TV volume should be set to a middle setting and the
overall listening volume should be adjusted via the Interior-Cinema remote control.
Connecting an additional audio source to LINE IN 2:
An additional audio source (e.g. MP3 player, CD player, etc.) can be connected to audio input LINE IN 2
(3) (3.5 mm stereo jack). The necessary connecting cable is not included in delivery.
Important note:
When connecting audio sources with variable output level (e.g. connection via headphone jack or a TV
set with variable audio output), the level of the audio source should be set in such a way that no distortion
can be heard at the maximum volume setting of the Magnat Interior Cinema 2.1 VA. The volume of the
audio source should also be taken into account. No distortions should be evident here either. The volume
of the audio source should also be taken into account. No distortions should be evident here either.
Mains connection:
Connect the power connector of the subwoofer (8) to an electrical socket via the mains cable (I).
OPERATION
Operating elements on the subwoofer (fig. 4):
Mains switch (6): After installation use this switch to turn on the device. If the device is not going to be
used for a prolonged period, it should be switched off.
STBY/ON button (5): This button can be used to switch between the standby and operating modes. This
function is also possible via the remote control.
Fuse (7): Only use a fuse with the parameters indicated next to the fuse holder, on the rear of the
amplifier.
The infrared receiver (fig. 5):
LED status indication (9): indicates the system's possible states:
• LED is illuminated red: The system is in the standby mode.
• LED is illuminated blue: The system is switched on and input LINE IN 1 is active.
• LED is illuminated purple: The system is switched on and input LINE IN 2 is active.
Sensor for the remote control (10): Please aim at this sensor when using the remote control.
Operation with the system remote control (fig. 6):
ON/STBY (11): Switches the device on when it is in the standby mode. If the LED does not illuminate,
actuate the power switch located on the rear of the subwoofer. Conversely the device can be switched
from power operation to the standby mode.
MUTE (12): Switches the sound on and off.
VOLUME (13): Increases (+) or decreases (-) the volume.
SUB (14): Increases (+) / decreases (-) the volume of the subwoofer.
SOURCE (Input selector switch) (15): Switches between the different audio sources (LINE IN 1, LINE
IN 2). The selected input is displayed via the LED (e) on the IR receiver (blue or purple).
GB
12