Getting Started; Installing The Software; Connecting To The Personal Computer - Sony VGP-UPR1A Mode D'emploi

Getting started

1 Installing the software

Download the software from the Web page below, and follow the installation procedure.
http://support.vaio.eu
After selecting the country, select "Accessories" for "Select Category, " select "VGP-UPR1A" for "Select
Model, " and then log in.
If you cannot download, contact the support center refered to in the manual(s) provided with your
personal computer.
Notes
Do not connect the product with the personal computer before installing the software.

Disconnect all USB devices connected to the personal computer.

To install the software, connect to the Internet first.

Before installing the software, ensure the latest Windows updates have been applied. Be sure to exit all other software.

Log on as "Administrator. "


2 Connecting to the personal computer

Notes
Install the software before connecting the product.

Be sure to connect the product directly to the USB connector of the personal computer. Do not connect through a USB

hub.
When connecting to a personal computer for the first time, disconnect all devices from this product.

The product does not support Windows Aero.

Movie playback and software that requires 3D processing are not supported on the display connected to this product.

1
Plug the AC adapter cable into this product.
2
Plug the supplied power cord into the AC adapter and then into an AC outlet.
3
Set the power switch of this product to "ON. "
POWER lights up.
4
Connect the product to the USB connector with  mark of the personal computer.
A screen that requests to reboot the personal computer may appear. In this case, select "Restart
Now. "

Tips
The screen may dim for a moment after connecting the product to the personal computer. This is a normal

characteristic of setup and is not a malfunction.
You can adjust the length of the product's USB cable by using the drain at the bottom.

Disconnecting the product
Note
When disconnecting the product from the personal computer, confirm that the connected devices can be disconnected
safely.
1
Exit the software being used by the USB device connected to the product.
2
Disconnect the USB connector connected to the personal computer.
4
GB