Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
STEP 5: ACTIVATING THE DEVICES
Switch on the power leading to the assembly location again. Make sure
to switch on power of the PoE-Switch / PoE-Injector you have connected to
the Sender.
The Diagnostic-LEDs of RJ45 jack of the Sender and Receiver should be blinking
and thus signaling an established power- (PoE) and network connection.
Please check the polarity of the 2-wire cable between the Sender and Receiver
and check also your PoE-Switch / PoE-Injector if the Diagnostic- LEDs are
not blinking.
DIAGNOSTIC-LEDS
You can check if the Sender and Receiver are properly connected by checking
the Diagnostic-LEDs. The Diagnostic-LEDs of RJ45 jack of the Sender and
Receiver should be blinking and thus signaling an established power- (PoE)
and network connection.
TECHNICAL SPECIFICATIONS
Dimensions:
33 x 25 x 88 mm (H x W x D)
1,30 x 0,98 x 3,46 in (H x W x D)
Power supply:
PoE-Switch or PoE-Injector
(IEEE 802.3 af/at), not included
Operating conditions:
-25 to 55°C / -13 to 131°F
Humidity 10 to 85 % RH
(non condensing)
Speed:
Up to 60 mbit/s at maximum
transmission range
Latency:
~ 0.01 ms
12
Connectors:
1x RJ45, 2x screw terminals
PoE:
PoE 802.3 af/at Mode-A and PoE +,
up to 30 W
Data line pair:
1/2 (+), 3/6 (-)
Range:
80 meters / 262 feet with unshielded
two-wire cable. When using
unshielded wires (e.g. simple bell
wire) between sender and receiver,
make sure that there are no other
current-carrying wires (or other
2-wire Ethernet PoE converters)
near the 2-wire cable. Electricity
generates an electromagnetic field
that significantly interferes with
Publicité
Table des Matières
