Domo DO8138 Mode D'emploi page 29

www.domo-elektro.be DO8138
FASTENING THE GRILL AND THE FAN BLADES
Remove the spinner from the motor drive (or remove it from the packaging). Loosen
the plastic screw from the motor drive. Position the grill behind the motor drive and
use the plastic screw to fasten the grill. (Fig. 1)
Place the fan blades on the motor drive. Make sure the pin on the motor drive fits
perfectly behind the fan blades (Fig. 2). Use the spinner to fasten the fan blades on the
motor drive.
Position the front grill on the rear grill and fasten them together with the help of the
attaching clip. Finally, use the screw at the top of the rear grill to fasten both halves of
the grill together firmly. (Fig. 3)
3
2
INSTRUCTIONS
Speed regulation with the help of the 4 buttons on the control panel.
0: off
1: low speed
2: high speed
To allow the fan to oscillate, push in the oscillation button. To stop the fan from
oscillating, pull the button up.
To direct the ventilation up or down. Unscrew the button on the
1
side of the motor drive. Push down or pull up gently on the grill to
adjust the direction up or down. Fasten the button again.
MAINTENANCE
This fan requires very little maintenance. Never try to repair the fan yourself. If it is
defective, have it checked and/or repaired by a qualified person.
Prior to assembling the fan or cleaning it, remove the plug from the outlet.
Keep the rear grill free of dust and other substances in order to allow free circulation
of the air around the motor. Do not disassemble the fan to remove dust from the motor.
You may clean the exterior of the machine with a soft moist cloth and a mild
detergent. Carefully dry the machine afterwards.
Never use corrosive or abrasive products to clean the machine.
Make sure that no water gets into the motor of the machine.
29