Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
• To remove the comb guide,
ensure the appliance is switched
off. Push the tab on the rear of the
comb guide away from the head
and lift off.
Taper Control
The taper control lever enables
fine cut adjustment for precision
clipping.
• To increase the cutting length,
push the lever down.
• To reduce the cutting length,
push the lever up.
INSTRUCTIONS FOR USE
Charging the Appliance
• Before
using
for the first time, charge the
battery
continuously
hours.
Maximum
capacity will only be reached
after 3 completed charging and
discharging cycles.
• Plug the charging adapter into
a suitable mains power socket.
The red LED indicator light will
flash when correctly connected
to the mains power and will
continuously flash until the
battery has fully charged. When
the battery is fully charged the
the
appliance
for
battery
LED indicator light will stop
flashing but remain on.
NOTE: Always place the clipper in
the base with the 'I/0' switch in the
0/OFF position.
• When the clipper is running low
on charge, the LED indicator
light will flash, warning there
is
approximately
of battery use remaining. A
3 hour charge will provide
approximately
use. A 30 minute quick charge
will provide approximately 30
minutes use.
• If the charging light starts to
flash rapidly (more than 4 flashes
per second) then the appliance
is faulty. If this happens then
please stop charging and remove
the adapter from the mains
and contact the customer care
service.
Preserving the Batteries
• In order to maintain the optimum
3
capacity of the rechargeable
batteries, the appliance should
be recharged for 3 hours
approximately every 3 months.
• Using the clipper on the mains -
ensure that the clipper is switched
off. Plug into a suitable mains
socket. Wait for approximately a
minute, and then switch on.
IMPORTANT: Do not use the
clipper in this mode for more than
20 minutes.
6
3
minutes
120
minutes
Publicité
Table des Matières
