Using The Appliance - ProfiCare PC-BHT 3074 Mode D'emploi

4. Close the battery compartment. Align the
turn the cover towards . The cover must snap into place.
Turning On / Off the Appliance
Slide the switch to turn the appliance on or off.
Installing and Removing Attachments
WARNING:
Always turn off the appliance before removing or installing attachments!
• You can take off an attachment by turning it anticlockwise and pulling it off.
• When mounting the accessories, note the guide on the appliance and the cut-outs
on the attachments. The attachments can only be placed in a certain position.
Tighten the attachment by turning it to the left until it clicks into place.
• To put on a comb attachment for the beard and body trimmer, proceed as follows:
Slide a blade of the shaving head into the prongs of a comb attachment. Press the
comb attachment firmly onto the shaving head. It must audibly snap in.
• To release the comb attachment, push an outer prong upwards.
CAUTION:
Do not press the middle tines up. They could bend or break off.
Shaving / Trimming of Beard or Body Hair
• Use the attachment with the two-sided shaving blade.
• Hair longer than 10 mm should be shortened first. This makes shaving them off
afterwards easier.
• If you would like to shorten the beard or body hair evenly, place a comb attach-
ment onto the shaving head. The comb attachments are marked with the cutting
lengths.
NOTE:
Start with the largest comb attachment and gradually shorten your beard or
body hair to the desired length.
46
PC-BHT3074_IM
marking with the

Using the Appliance

symbol. Then
17.10.19