Using The Headphones - Medion LIFE P69123 Mode D'emploi

Using the headphones

7. Using the headphones
 Switch on the audio device that is connected to
the transmitter.
 Switch on the transmitter using the switch at
the rear of the device.
 The LED flashes orange until a connection is
made to the headphones and then remains on
permanently.
 Press the power button on the right earpiece.
The red operating LED underneath the power but-
ton lights up until radio contact is made with the
transmitter.
If no transmitter is in range, the LED goes out after
5 minutes and the headphones switch off.
As soon as the green LED lights up permanently,
a connection has been established and the audio
signal will be transmitted.
 Set the volume to a low level.
 Set the length of the headband so that the
headphones sit comfortably.
 Put the headphones on.
 Set the desired volume.
 To connect the headphones directly to the
playback device, use the supplied 3.5 mm au-
dio cable.
114 of 122