Explanation Of Signs; Supplied Parts; Description Of Parts; Assembly - BOMANN HDR 9013 CB Mode D'emploi D'origine

Cleaning tank: For ground-in dirt, you can also use a cleaning agent. The cleaning tank is attached to the
stand pipe. Use cleaning agent sparingly. Follow the recommendations of the manufacturer.
Never direct the high-pressure jet at
- people
- animals
- the high-pressure cleaner
- electrical parts/equipment
Do not connect to the drinking water system!
According to the applicable regulations, the device may never be operated from the
water mains without a backflow preventer.
Use a backflow preventer according to EN 12729 Type BA.
Water which has flowed through the backflow preventer is not drinkable.
Noise levels
In conformance with DIN EN ISO 3744, the sound power level L
at 99 dB.
Protective insulation
These devices protect the user against contact with live parts through double or thicker
insulation.
No ground conductor (ground) may be connected to these devices.
Only two-pin plugs should be used in connection with two-core cables.

Supplied Parts

Units Description
1 Motor unit with wheels and handle
1 Accessories holder
1 High-pressure hose maximum 36 MPa/50 C°
1 Spray gun
1 Stand pipe with fastener
1 Jet pipe with high-pressure nozzle
1 Cleaning tank, 2-part
1 Inlet hose adapter
1 Pin, nozzle cleaner

Description of Parts

1 Spray gun with lock
2 Stand pipe
3 Holder for accessories
4 Quick fastener
5 ON/OFF main switch
6 High-pressure hose
7 High-pressure outlet
8 High-pressure nozzle
9 Jet pipe
10 Pin for cleaning
11 Water connection with filter
Not shown
Inlet hose (not included)
Cleaning agent tank

Explanation of Signs

Spare part number
Remove the motor and accessories from the box. Remove any packing
material.
8935970
High-pressure hose onto the high-pressure cleaner
8935971
Completely uncoil the hose.
8935972
Connect the high-pressure hose to the high-pressure outlet (7). Turn the
8935973
connector clockwise hand-tight onto the screw thread.
8935974
8935975
High-pressure hose onto the spray gun
8935976
Screw the nut onto the spray gun thread. Tighten the nut with a 17 mm
8935977
socket.
Stand pipe to the spray gun
The stand pipe has a quick fastener. Attach the blank metal end to the
spray gun.
Push and turn clockwise at the same time to lock the quick fastener.
Open the quick fastener by first pushing together the parts and then
turning the pipe anti-clockwise.
Jet pipe to the stand pipe
The jet pipe with nozzle can only be fitted to the stand pipe. These parts
have a quick fastener (4).
Push and turn clockwise at the same time to lock the quick fastener.
Open the quick fastener by first pushing together the parts and then
turning the pipe anti-clockwise.
Cleaning agent tank to the stand pipe
The cleaning agent tank can only be fastened to the stand pipe (2). It
also latches into the quick fastener.
has been measured
WA

Assembly

39