Loc8tor Mode D'emploi page 4

SETTING UP YOUR LOC8TOR
1. Insert batteries (2 x AAA)
With the Loc8tor buttons facing you push forwards and remove right hand side panel.
Insert batteries (See diagram in battery compartment for correct insertion) and replace
side panel.
Loc8tor has no ON or OFF button. To use press any button. It will automatically turn
ON.
•
2. Register Tags
•
Pull out white strip in Tag to activate batteries
•
Tag beeps and red light flashes twice
Place Tag next to Handheld making sure all other Tags have been
•
moved more than an arms length away
•
Press Yellow register button on the Handheld then select yes
•
Follow on-screen instructions (see below Naming Tags)
Repeat process for each new Tag
•
3. Naming your Tags
Tags can be personalised with a name of your choice up to 10
•
characters long
•
Use navigation ring to highlight letters
•
Press White button to select
Press OK to finish
4. Attach Tags
Depending on use Tags can be attached with adhesive strips, key ring loop or left loose.
Adhesive strips
Best used when attaching to a hard, flat surface. Peel off backing to attach.
Sticky tabs are not permanent but increase their bond with time. Ideally leave for a
Minimum of 10 minutes. Strongest bond after 24 hours.
To remove insert flat tool under Tag and gently twist / prise off.
Key ring loop
Best used to attach Tag to items such as key ring, bags and belt loop.
Push loop through the Tag hole and then pull ring through the loop.
4
1.
3.
4.