Table des Matières
Publicité
BATTERY REPLACEMENT
P902-P904 MODELS
WARNING: before operating on the transmitter, make sure that the RRC radio receiver is not powered. Acciden-
tally pressing a key may activate the corresponding device and create a dangerous situation.
WARNING: danger of explosion if battery is replaced with an other of incorrect type.
• Remove the transmitter base by unscrewing the four screws using a
Phillips screwdriver.
• Remove the battery from the battery holder sliding it outwards with-
out using metal tools.
• Insert the new battery (of the type indicate in the technical character-
istics) paying attention to polarity of the positive pole (+) as shown on
the metal battery holder.
• Close the transmitter base, checking that it sits correctly in the gasket
groove, located on the front of the transmitter, in order to restore the
seal.
• Tighten the four screws.
WARNING: once the transmitter is assembled, verify that the
LED does not remain on constantly. If the LED is on, reopen the
transmitter and verify that it was assembled correctly.
At the end of its useful life, the battery contained in the product must
F
be disposed of separately from other separated urban waste. Dispose
of the battery in accordance with the provisions of local law.
MAINTENANCE
The RRC pocket radio transmitter does not require particular maintenance. Use a soft cloth moistened with water when
cleaning it. Do not use chemical or abrasive products.
TECHNICAL DATA
MODELS
INPUT CHARACTERISTICS
Power supply
Absorption during transmission
CHARACTERISTICS OF THE TRANSMITTER
Number of keys
Carrier frequency
Modulation
FCC ID
GENERAL
Operating temperature
Dimensions (W x H x D)
Weight (including the battery)
This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions:
1) This device may not cause harmful interference, and
2) this device must accept any interference received including interference that may cause undesired operation.
®
QUICK
RESERVES THE RIGHT TO MODIFY THE TECHNICAL CHARACTERISTICS OF THE EQUIPMENT AND THE CONTENTS OF THIS MANUAL WITHOUT PRIOR NOTICE.
RRC P902/904 - REV001A
MAINTENANCE - TECHNICAL DATA
P902
2
BATTERY
HOLDER
CR2450 3V LITHIUM
BATTERY
CR2450 3V lithium battery
13 mA
913.7 Mhz
FSK
O2W-TXP
from -15°C to +70°C
60 x 47 x 23 mm
34 g
GB
SCREWS
TRANSMITTER
BASE
TRANSMITTER
FRONT
P904
4
5
Publicité
Table des Matières
