Renegade 1TREN008OBL Manuel D'utilisation Et De Sécurité page 7

INSTALLATION ON MASONRY WALLS
Use masonry anchors that are 0.6 cm (1/4") in diameter and have a minimum length
of 7.1 cm (2-3/4"), along with appropriate drill bits and fasteners.
INSTALLATION ON STEEL WALLS
So that the weight of the rack is properly transferred to the wall, it must be mounted
to a part of the structural framework either at the top and bottom, or at the sides.
First install floor to roof verticals (such as 2x4's) and secure with appropriate
fasteners every 30 cm (12"). Pre-drill holes, then attach the rack to the verticals using
lag screws that are 0.6 cm (1/4") in diameter and have a minimum length of 7.1 cm
(2-3/4").
INSTALLATION ON WOOD FENCES
Wood fences are not designed to carry a load, so they must be structurally reinforced.
Install proper horizontal supports between the fence posts. Pre-drill holes, then attach
the rack to the fence posts using lag screws that are 0.6 cm (1/4") in diameter and
have a minimum length of 7.1 cm (2-3/4").
7