OHAUS a-AB23PH Mode D'emploi page 7

AB23PH Bench pH Meter
Controls
Button
Exit
Store
Recall
pH/mV
Read/Enter
Auto - Stop
Buffer
Temp.
Cal
Cal.Data
Figure 1-2 Control Panel
Press & release
Turns on the meter

Cancels the current measurement

Exits calibration

 Stores the current measurement result
 When checking the stored
measurement results, moves to the
previous record.
 When setting parameters, increases
the setting value or displays the
previous option.
Switches between pH and mV mode.
 Starts or ends measurement
 Ends the current measurement in the
auto endpoint mode and shows the
result
Confirms settings and stores setting

parameters
Selects buffer group

When checking the stored

measurement results, moves to the
next record.
When setting parameters, decreases

the setting value or displays the next
option.
Starts calibration
EN-5
Press & hold
for 3 seconds
Turns off the meter
Recalls stored
measurement results
/
Switches between
auto and continuous
endpoint mode
Auto
Continuous
Enters temperature
setting, selects
temperature unit and
sets MTC
temperature (The
default is 25.0 C°
degrees)
Recalls the latest
calibration data:
slope and offset