Box Contents; Product Use; Control Panel - Greencut MIG100 Manuel D'utilisation

50

BOX CONTENTS

This machine includes the following items which you will find inside the box:
-
1x Welder
-
1x Welding mask
-
1x Brush with ice pick
-
1x Ground cable
-
1x Torch
-
1x Instruction manual
• Remove the product and accessories from the box. Make sure all items are present.
• Inspect the product to ensure that it has not been broken or damaged in transit.
• Do not discard the packaging material until you have carefully inspected and satisfactorily used the product.
ATTENTION: If any part is missing or damaged, contact the Official Technical Service. Do not use
this product without having replaced the missing or damaged part. Using this product with
damaged or missing parts can cause serious injury to the operator.

PRODUCT USE

PANEL OPENING
ATTENTION: Make sure the welder is not plugged in.
To open the panel, pull the safety bar upwards and, while holding it down, pull the cover.

CONTROL PANEL

1. THERMAL OVERLOAD INDICATOR
If the recommended duty cycle is exceeded and the current is too high, the yellow overload indicator light will come
on and the welder will turn off automatically. When the welder has cooled (approximately 5 to 10 minutes), the power
will return to the unit and you can restart welding.
2. ON / OFF SWITCH
When the welding machine is activated, a green light will come on. When you are no longer using the welder, you
must turn it off and disconnect it from the power supply
3. FUNCTION SELECTOR (MAXIMUM AND MINIMUM, 1 AND 2)
When used simultaneously, these switches will allow you to reach two power levels:
- MIN-1
35A
- MAX-1
48A
4. CURRENT INTENSITY CONTROL
As a general rule, a higher current requires a higher speed.
MIN-2 70A
MAX-2 90A