Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
1
2
3
4
002565
2.
To install the blades, loosely attach the adjusting
plate to the set plate with the pan head screws
and set the mini planer blade on the gauge base
so that the cutting edge of the blade is perfectly
flush with the inside flank of the gauge plate.
3.
Set the adjusting plate/set plate on the gauge
base so that the planer blade locating lugs on the
set plate rest in the mini planer blade groove, then
press in the heel of the adjusting plate flush with
the back side of the gauge base and tighten the
pan head screws.
4.
It is important that the blade sits flush with the
inside flank of the gauge plate, the planer blade
locating lugs sit in the blade groove and the heel
of the adjusting plate is flush with the back side of
the gauge base. Check this alignment carefully to
ensure uniform cutting.
5.
Slip the heel of the adjusting plate into the groove
of the drum.
1
7
010705
6.
Set the drum plate over the adjusting plate/set
plate and screw in the three hex flange head bolts
so that a gap exists between the drum and the set
plate to slide the mini planer blade into position.
The blade will be positioned by the planer blade
locating lugs on the set plate.
7.
The blade's lengthwise adjustment will need to be
manually positioned so that the blade ends are
clear and equidistant from the housing on one
side and the metal bracket on the other.
8.
Tighten the three hex flange head bolts (with the
socket wrench provided) and rotate the drum to
1. Pan head screw
2. Adjusting plate
3. Planer blade
locating lugs
4. Gauge plate
5. Heel of adjusting
plate
5
6. Set plate
7. Inside flank of
6
gauge plate
7
8. Gauge base
8
9. Back side of
9
gauge base
10
10. Mini planer blade
1. Mini planer
6
blade
5
2. Groove
3. Set plate
4. Hex. flange
head bolt
4
5. Drum plate
3
6. Drum
2
7. Adjusting plate
check clearances between the blade ends and the
tool body by hand.
9.
Check the three hex flange head bolts for final
tightness.
10. Repeat procedures 1 - 9 for other blade.
For tool with standard planer blades
004841
To remove the blades on the drum, unscrew the three
installation bolts with the socket wrench. The drum cover
comes off together with the blades.
To install the blades, first clean out all chips or foreign
matter adhering to the drum or blades. Use blades of the
same
dimensions
oscillation/vibration will result, causing poor planing
action and, eventually, tool breakdown.
2
3
4
5
002555
Place the blade on the gauge base so that the blade
edge is perfectly flush with the inside edge of the gauge
plate. Place the adjusting plate on the blade, then simply
press in the heel of the adjusting plate flush with the
back side of the gauge base and tighten two screws on
the adjusting plate. Now slip the heel of the adjusting
plate into the drum groove, then fit the drum cover on it.
Tighten the three installation bolts evenly and alternately
with the socket wrench.
2
3
4
5
6
7
002556
5
and
weight,
1. Bolt
1
2. Drum
3. Planer blade
4. Drum cover
5. Adjusting plate
1. Inside edge of
gauge plate
2. Blade edge
3. Planer blade
4. Adjusting plate
1
5. Screws
6. Heel
7. Back side of
8
gauge base
8. Gauge plate
9
9. Gauge base
or
drum
Publicité
Table des Matières
