PROCONCEPT PLG025 Manuel De L'utilisateur page 4

IMPORTANT SAFETY INSTRUCTIONS
IMPORTANT: If you experience discomfort, redness and swelling of the fingers
followed by whitening and loss of feeling, consult your physician before further
exposing yourself to vibration and cold.
ADDITIONAL SAFETY RULES FOR GAS TRIMMERS
DO NOT USE ANY OTHER FUEL than that recommended in your manual.

Always follow instructions in the Fuel and Lubrications section of this manual.
Never use gasoline unless it is properly mixed with 2-cycle engine lubricant.
Permanent damage to engine will result, voiding manufacture's warranty.
DO NOT SMOKE while refueling or operating equipment.

DO NOT OPERATE UNIT WITHOUT A MUFFLER and properly installed muffler

shield.
DO NOT TOUCH or let your hands or body come in contact with the muffler.

Hold unit with thumbs and fingers encircling the handles.
DO NOT OPERATE UNIT IN AWKWARD POSITIONS; off balance, outstretched

arms, or one-handed. Always use two hands when operating unit with thumbs
and fingers encircling handles.
DO NOT RAISE LINE HEAD above ground level while unit is operating. Injury to

operator could result.
DO NOT USE UNIT FOR ANY PURPOSE OTHER than trimming lawn or

garden areas.
DON'T OPERATE UNIT FOR PROLONGED PERIODS. Rest periodically.

DON'T OPERATE UNIT UNLESS DEBRIS SHIELD IS INSTALLED AND IN

GOOD CONDITION.
DON'T ADD, REMOVE OR ALTER ANY COMPONENTS OF THIS PRODUCT.

Doing so could cause personal injury and/or damage the unit, voiding the
manufacturer's warranty.
DON'T OPERATE YOUR UNIT NEAR OR AROUND FLAMMABLE LIQUIDS

OR GASES whether in or out of doors. An explosion and/or fire may result.
TURN UNIT OFF BEFORE SETTING IT DOWN.

KEEP HANDLES DRY, CLEAN AND FREE OF FUEL MIXTURE.

KEEP LINEHEAD AS CLOSE TO GROUND AS PRACTICAL. Avoid hitting

small objects with linehead. When cutting on a slope, stand below linehead.
NEVER cut or trim on a hill or slope, etc if there is the slightest chance of
slipping, sliding or losing firm footing.
CHECK AREA YOU WILL BE TRIMMING FOR DEBRIS THAT MAY BE

STRUCK OR THROWN DURING OPERATION.
KEEP ALL PARTS OF YOUR BODY AND CLOTHING AWAY FROM LINE

HEAD when starting or running engine. Before starting engine, make sure
linehead will not come in contact with any obstacle.
STOP ENGINE BEFORE EXAMINING TRIMMING LINE.

ALWAYS KEEP THE DEBRIS SHIELD, LINEHEAD, AND ENGINE FREE OF

DEBRIS BUILD-UP.
SPECIFICATIONS
Engine:
Displacement:
Fuel capacity:
Trimmer head:
Drive shaft length:
Cutting width:
4
PLG025b
Air-cooled, 2-cycle gas
25 cc (1-1/2 cu.in.)
800 ml (27 US fl.oz.)
Twin line bump
120 cm (47-1/4")
430 mm (17")
!