Introduction; What's In The Box; General Information; Displays - Telecom Behnke Myintercom Mode D'emploi

Instructions for 2-wire transmitter-receiver
GB

Introduction

intROduCtiOn
1.
1.1. What's in the box
▸
2-wire transmitter in weatherproof housing
▸
2-wire received for installation in the
protected indoor area
▸ 2 BNC screw terminal adapters
▸
These instructions
1.2. General information
With the Behnke 2-wire system you can use the
existing wiring on site to also connect Behnke IP
products. The Behnke 2-wire system transmits
ethernet and power via only 2 wires. If using
coaxial cables the maximum bridgeable cable
length is 200m, with telecommunication cables
it is 100m. Only the receiver indoors has to be
supplied with electricity. It supplies not only
the outdoor transmitter but also the IP terminal
device connected outdoors by means of PoE
according to IEEE802.3af (max. 15.6W).
1.3. Displays
Connection
Ethernet port Power
2-wire port
12
LED Off
No power supply
Link Status No ethernet connection
PoE Out No PoE
10 / 100 No Verbindung
On
Power supply OK
Ethernet connection OK
PoE output OK
100 MBit
www.behnke-online.de
Flashing
10 MBit