Functional Description - Lindemann Limetree Headphone Mode D'emploi

FUNCTIONAL DESCRIPTION

Limetree
Headphone
on
1 2
A1 A2
5
A1 A2 A3
Volume
3 4
A3 Output 5V DC
6
1 2 3
30-50 R
1. The toggle switch on the front of the headphone amp
has two functions: press it briefly to turn the unit on. A
second short push will turn the unit off again. To switch
between the inputs, press and hold the toggle in the
upper position for 3 sec.
2. 3.5 mm (1/8 in) headphone socket. Plugging in the
headphone will turn on the headphone output and
the line output is muted.
Warning: the headphone impedance should not fall
below 32 ohms.
3. Function indicators for the analog inputs A1 to A3.
4. Volume control.
Caution: the control range of the volume control can be
adapted to the headphone impedance on the bottom side
of the device.
5. Analog inputs A1 to A3.
6. Line output for connecting a power amplifier or active
loudspeakers.
7. 5V DC low voltage connector.
Caution: only the included plug-in power supply must be
used.
7
EN 13